Automatisk avfallspapirpresser

The waste paper baler on the market is mainly divided into two types: horizontal and vertical. The vertical waste paper baler has a relatively small volume because the packaging size is also relatively small and the efficiency is not high. The horizontal waste paper baler is bulky compared to the vertical baler, but its compression force is also larger than that of the vertical baler, the size of the baler is relatively large, the efficiency of the bale is high, and it is easy to operate automatically because The general waste paper baler adopts a horizontal form. The horizontal waste paper baler is easy to realize automation, can improve the overall efficiency of baling, and save the labor cost of baling.

The motor used in the waste paper baler includes two parts: a stator and a rotor. The stator of the waste paper baler motor is also called the armature, including the frame, end cover, armature core, armature winding device and other components. The armature core is installed in the inner circle of the base, which is the bracket of the generator and is made of cast iron. End caps are installed at the two ends, the upper ring is used for lifting, the round hole at the lower foot is for mounting bolts, and the grounding bolt on the machine base is for installing grounding wires. In order to dissipate heat and facilitate maintenance, ventilating windows are left on the end caps, which are covered with louvers to prevent intrusion of debris. The rotor includes rotor core, rotor (excitation) winding, fan, shaft and other components. The rotor core is the narrow part of the waste paper baler motor, which is made of 1-2M thick steel/stack. The iron core is fixed on the magnetic yoke with a pupa bolt. The magnetic yoke is made of a single piece of low carbon and is sleeved on the uranium through a steel rod.